[1]齐玉成,赵会军,邵悦,等.波纹板聚结分离器分离效率影响因素研究[J].常州大学学报(自然科学版),2016,(02):67-72.[doi:10.3969/j.issn.2095-0411.2016.02.013]
 QI Yucheng,ZHAO Huijun,SHAO Yue,et al.On the Influencing Factors of Separation Efficiency of Corrugated Plate Coalescing Separator[J].Journal of Changzhou University(Natural Science Edition),2016,(02):67-72.[doi:10.3969/j.issn.2095-0411.2016.02.013]
点击复制

波纹板聚结分离器分离效率影响因素研究()
分享到:

常州大学学报(自然科学版)[ISSN:2095-0411/CN:32-1822/N]

卷:
期数:
2016年02期
页码:
67-72
栏目:
石油与天然气工程
出版日期:
2016-03-30

文章信息/Info

Title:
On the Influencing Factors of Separation Efficiency of Corrugated Plate Coalescing Separator
作者:
齐玉成赵会军邵悦慈智朱伟
江苏省油气储运技术重点实验室(常州大学),江苏 常州 213016
Author(s):
QI YuchengZHAO HuijunSHAO YueCI ZhiZHU Wei
Jiangsu Key Laboratory of Oil & Gas Storage and Transportation Technology, Changzhou University,Changzhou 213016, China
关键词:
聚结分离器分离效率影响因素最优方案
Keywords:
coalescence separator separation efficiency influencing factors best solution
分类号:
TQ 316334
DOI:
10.3969/j.issn.2095-0411.2016.02.013
文献标志码:
A
摘要:
室内搭建实验平台,配制与生产单位相似浓度的油水混合液进行室内试验,针对流量、板间距、聚结板倾斜角度、板组数、温度5个影响因素进行01~04〖KG3x〗m3/h 4个不同流量下的试验,优化试验参数,试验结果表明:流量Q为01〖KG3x〗〖KG3x〗m3/h时分离效率保持在85%以上,高于其他流量下的分离效率。板间距增大,分离效率变低,板间距为063厘米时处理效果好。当Q=01〖KG3x〗m3/h时,聚结板组出口处倾斜15°时分离效果好,随着板组数增多,分离效率提高。温度对分离效率有一定的影响,但是在含油质量浓度为150〖KG3x〗mg/L时试验效果不明显。
Abstract:
By setting up the experimental platform indoor, similar unit concentrations of oilwater mixture were prepared and produced for indoor test. It was tested under four different flow rates ranging from 01〖KG3x〗m3/h to 04〖KG3x〗m3/h on five factors:flow, plate spacing, coalescence plate tilt angle, plate number and temperature, then the experimental parameters were optimized. The experimental results show that when the flow rate is 01〖KG3x〗m3/h, the the separation efficiency is maintained at above 85%, much higher than the separation efficiency of other flow rates. When the plate space increases, the separation efficiency gets low. And when the plate space is 063〖KG3x〗cm, the treatment effect is good. When the flow rate is 01〖KG3x〗m3/h and the coalescence plates group exit inclination sets at 15 degrees, the separation effect is good. With the increase of the number of plate group, the separation efficiency is improved.Although the temperature has a certain influence on the separation efficiency, when the oil concentration is 150〖KG3x〗mg/L, the test result is not obvious.

参考文献/References:

[1] 李方文,吴建锋,徐晓虹,等.油田开采水中铁的去除及其对浊度的影响[J].石油化工高等学校学报,2007,20(2):2325.
[2]王临红,赵振兴,韩桂华,等.含油污水除油净水技术研究与发展[J].工业水处理,2005,25(2):58.
[3]罗彩龙,朱琴.国内油田含油污水处理现状与展望[J].石油和化工设备,2010,13(11):5557.
[4]隋智慧,秦煜民.油水分离技术的研究进展[J].油气田地面工程,2002,21(6):115116.
[5]冯叔初,郭揆常.油气集输与矿产加工[M].东营:中国石油大学出版社,2006:278.
[6]张银鸽,于萍,刘士雷.聚结构件倾角对分离器分离效果影响的数值模拟[J].石油矿场机械,2013,42(3):4245.
[7]陈文征,张贵才,尹海峰.波纹板聚结油水分离技术研究进展[J].石油矿产机械,2007,36(5):2729.
[8]张黎明,何利民,王涛,等.重力分离器聚结构件数值模拟及优化研究[J].化工机械,2008,35(1):1721.〖LL〗
[9]张黎明,何利民,王涛等.含聚结构件油水分离器性能研究[J].高校化学工程学报,2009,23(2):345350.
[10]王敏,杨昌柱.一种波纹板聚结油水分离器的研制[D].武汉:华中科技大学,2004.
[11]候海瑞.液液聚结分离器原理及石油化工中的应用[J].过滤与分离,2013,23( 3):2932.
[12]孙治谦,王振波,吴存仙,等.油水重力分离过程油滴浮升规律的实验研究[J].过程工程学报,2009,9(1):123127.
[13]孙治谦,王振波,金有海.油水重力分离原理及聚结破乳机理初探[J].化工机械,2009,36 (6):636639.
[14]闫志刚,杨中奇,刘帅男.高效斜板分离器结构研究与开发[J].化工设计,2012,22(1):3740.
[15]曹书翰,陈立功,刘先杰,等.粗粒化技术对水包油乳状液分离特性的影响[J].后勤工程学院学报,2013,29(2):2529.

相似文献/References:

[1]蔡小华,袁惠新,戎红仁.旋流器用于油品脱水的研究[J].常州大学学报(自然科学版),2005,(02):37.
 CAI Xiao -hua,YUAN Hui -xin,RONG Hong -ren.Investigation into the De -Watering of Oil with Hydrocyclones[J].Journal of Changzhou University(Natural Science Edition),2005,(02):37.

备注/Memo

备注/Memo:
收稿日期:20150723。基金项目:江苏省自然科学基金资助(BK20150269)。作者简介:齐玉成(1991—),男,山东济南人,硕士生。通讯联系人:赵会军(1965—),Email:zhj@cczu.edu.cn
更新日期/Last Update: 2016-03-20